Advantages of wire rope fall arrester

The components of the steel wire rope fall arrester include upper hook, lower hanging ring, steel belt, pawl, steel wire rope, etc. in the process of use, through the back and forth movement of the operator, the steel wire rope of the fall arrester will freely extend into and out of the fall arrester with the movement of the personnel.

Although the steel wire rope is the standard steel wire rope of each safety fall arrester, and we may simply think it is an ordinary steel wire rope during our observation, in fact, in all types of fall arresters, the models of fall arresters are different, and the thickness and length of the steel wire rope carried on their body are also different. Different tonnage models of fall arresters are treated differently, especially the length and diameter of its steel wire rope can be set according to the bearing capacity of the fall arrester, which can greatly improve the safety factor of the safety fall arrester and reduce the probability of high-altitude falling accidents.

High compressive strength, wear resistance, durability, mildew resistance, corrosion resistance, simple and lightweight. Instruction manual: each time the steel wire rope is applied, it is necessary to check the appearance. In the whole process of application, it is also necessary to pay attention to the inquiry. The experiment needs to be carried out once a half to a year, with the provision that the main components are not damaged. In case of damage and mildew, it shall be immediately reflected and stopped to ensure the safety of actual operation. The steel wire rope must be checked before application. If it is found damaged, it shall be stopped. When wearing, the theme activity buckle shall be fastened, and fire and organic chemical objects shall not be touched. The steel wire rope shall be kept clean and stored properly after use. After getting dirty, it can be cleaned with warm boiled water and soap solution and dried in a cool place. It shall not be soaked with boiled water or baked in the wind, sun and fire. After one year of application, all-round inspection shall be carried out, and 1% of the applied components shall be taken out for tensile test to meet the standard if there is no damage or major deformation of each component.