Two basic conditions that a safety belt must meet

Safety belt is a protective equipment to prevent high-altitude operators from falling. Because the higher the falling height, the greater the impact force. Therefore, the safety belt must have the following two basic conditions: (1) it must have sufficient strength to bear the impact force when the human body falls; (2) It can prevent the human body from falling to a certain limit that can cause injury (that is, it should be able to pick up the human body before this limit and stop falling). This condition needs to be explained again that when the human body falls down from a height, if it exceeds a certain limit, even if the human body is pulled by the safety belt, it will also cause internal organs injury and death due to too much impact. Therefore, the length of the safety belt should not be too long, and there should be a certain limit.

Wearing sequence) connect the harness and safety rope in one step, fasten the chest belt in the second step, fasten the belt in the third step, fasten the leg belt in the fourth step, and finish wearing the fifth safety belt. Appearance: the part of the belt in contact with the waist must be covered with soft materials, the welder's lifting rope must be covered completely, and other lifting ropes only need to be partially covered, but the lifting rope is not covered; There shall be no locking parts on the strand. The surface of safety device accessories must be clean, free of pits and cracks, and must be rust proof.

In order to ensure the safety of the safety belt, it shall not be used at high temperature, and the rope shall not be knotted for use. During each use, the appearance inspection shall be conducted, and the use shall be stopped immediately in case of damage; The safety belt shall be installed in strict accordance with the standard requirements. When it is used with other equipment, it shall be installed under the guidance of certified personnel. The selection of rope shall match the actual tension requirements. The equipment shall be selected for fixation, and hasty installation is not allowed.