How is the fall arrester connected to the safety belt

If there is no safety belt but directly with your own belt, the excessive impact force at the moment of falling will cause secondary injury to the human body, ranging from strangulation to unimaginable. With the assistance of safety belt, the pressure released instantly can be distributed throughout the body, so as to reduce the injury to a certain part. This is the advantage of safety belt equipped with fall arrester. How is the fall arrester connected to the safety belt? The connection is divided into five steps:

1. Hook the flat steel hook of the fall arrester to the semicircular ring of the safety belt. The direction of the suspension rope is upward, and the locking device is on the outside of the belt.

2. Carry the safety belt on your back. Specific operation steps: 1) move the buckle on the safety belt backward to expose a gap between the buckle and the clamp body. 2) Pass the safety belt through the gap, and then pass the safety belt through the card body and belt clip. 3) Place the cushion under the safety belt clip and tighten the safety belt. Hang the flat steel hook on the steel wire rope on the safety belt.

3. When the operator reaches the working position, pull out a certain length of webbing at the normal speed, hold the flat steel hook to make a circle of the suspension rope on the stable support around the operator, and hook the flat steel hook to the suspension rope itself.

4. If the movement range of the staff exceeds 3M, remove the flat steel hook, hang the hook on the belt, and move it to the working position. Then hang the flat steel hook on the surrounding stable support.

Considering the special significance of anti falling safety devices before purchase, they tend to purchase anti falling devices produced by manufacturers with testing certificates, formal qualifications and good quality. Only high-quality fall arresters can protect the safety of high-altitude workers, and have a long service life. They will not easily have various faults and problems, and will not bring obstruction effect to high-altitude operations. After work, remove the fall protector from the safety belt and put it into the box for storage.